Ford Mustang Forum banner

hesitate

  1. 04 GT Cold engine sputter/miss under low rpm load

    4.6L Tech
    Okay, so I have an 04 GT with the basic mods (CAI, TB, plenum, X-pipe w/ high flow cats, MAC catback, and 3.73's) I've noticed this for a while, but haven't really cared much to try to find a solution. No better time than the present, right? Basically, when the engine is still cold and I try to...
  2. 1966 mustang 289 hesitation

    Classic Tech
    Hi all I have a 1966 mustang gt with the a code engine. It's mostly stock but has an edlbrock 289 rpm performer intake and a holley 600 and try y headers also a crane cams xr 700 electronic ignition box. The car ran a little ruff at lower rpm and hesitates on acceleration. So I replaced the cap...
  3. Convertible Top Struggles

    4.6L Tech
    Hey guys out of nowhere my convertible top started to struggle. To lift it off i have to hold the button and push it off and up until it catches and then when i put it back on i hear the motor go for a second or two before the top starts to lift and when it does lift the passenger side comes up...
  4. 1966 289 2V Won't Peel Out

    Classic Tech
    Before I had my engine and transmission rebuilt in my 1966 Mustang with a 289, automatic transmission, and 2V carburetor, I could peel out with no problems. I could just be stopped, then stomp the gas pedal and I'd spin the tire (yes only one tire spins). Now that I've had it all rebuilt, I...
  5. 1966 Mustang 289 Hesitates or Bogs Down When I Floor It

    Classic Tech
    Hi everyone, I'm really new here to the forums. I've found a lot of helpful stuff over the past several months as I've been working on my '66 coupe. Here's what I have. 1966 Mustang Coupe 289 c.i. 2V carb - original, rebuilt recently Automatic C4 trans. Hedman long tube headers Dual Flowmaster...
  6. 2005 Mustang GT V8 4.6 Failure motor hesitate after 3000 RPM

    2005-2010 Mustang GT Tech
    Hi, i have a mustang GT 2005 V8 4.6 Failure motor hesitate after 3000 RPM but only after 60 KM/Hr, i scanned with OBD II and i got P0357 thats why i replaced the 7 coil, but the failure remain, somebody can help me? I also woul like to know where the EGR Valve is and the location of the...
  7. 2006 Mustang GT hesitating on the freeway!?

    2005-2010 Mustang GT Tech
    I have a 2006 GT Mustang. I love the car but it has some hesitation to it lately. I was on the freeway racing and I downshifted from 5th to 3rd and it didn't want to go. The rpm's when up but it was like I’m done. It would move fine once I shifted into 4th but why in the world would it hesitate...
  8. Weak Acceleration

    V6 Talk
    I have a 2002 V6. Most of the time when I accelerate, it takes a while to get some speed. Sometimes as I'm accelerating, I hear what sounds like a backfire, a deep 'poof' 'pop' sound, sometimes from under the hood. When I brake to a stop, my RPM's go down under 1K, and it shakes a little like it...
  9. Very noisey hum from fuel pump

    V6 Talk
    I Have Got A Probelm With My 3.8l 1986 Cfi. At Times The Car Wants To Stall . Wether I'm Sitting At A Idle At A Light Or Driving At Any Speed, It Seems Like It I Got To Butterfly The Gas Pedal To Keep It Running. It Wants To Drop Rpm's Quickly And Then Stall . It Must Be Fuel Related. Any...
Top