Ford Mustang Forum banner
Cancel

Search Results for ‘install heads’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

1965 1966 1967 1968 2.3 2005 2006 2007 2011 289 3.8 302 4.6 5.0 alternator american iron cmc mustang automatic battery brakes bullitt cai cam cj pony parts classic clutch cobra cold air intake conversion convertible coupe electrical engine engine swap exhaust flowmaster ford ford gt fox body foxbody fuel fuel pump gears gt500 headers headlights heads hood horsepower idle ignition install intake interior introduction leak lights mach 1 manual misfire mods muffler mustang mustang car show mustang gt noise oil paint parts performance power problem problems radio rear end rebuild rims roush s197 sale sct shelby sn95 springs starter steeda supercharger suspension swap throttle body timing tires transmission tune tuner turbo v6 mustang video videos wheels wiring
  1. 5.0L Tech
    I recently bought some GT40P heads without pushrods off Ebay and I bought new hardened pushrods for them also. How do I install them? If I understand it right, I need to check piston to valve clearance. Do I need to crank it over until each piston raises and tighten down individually? If so...
    foxbody gt40p heads install heads pushrods
  2. 5.0L Tech
    I was looking to purchase these heads for a 88 gt 5.0 302. I was wondering if they will bolt right onto the original block(of course with new gasket n hardware).Also any info on clearence issues or what problems I may run into would be great. Thanks
    gt-40heads install heads
1-2 of 2 Results
Top