Ford Mustang Forum banner
Cancel

Search Results for ‘interchangeable’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results

Search Tags

1965 1966 1967 1968 2.3 2005 2006 2007 2011 289 3.8 302 4.6 5.0 alternator american iron cmc mustang automatic battery brakes bullitt cai cam cj pony parts classic clutch cobra cold air intake conversion convertible coupe electrical engine engine swap exhaust flowmaster ford ford gt fox body foxbody fuel fuel pump gears gt500 headers headlights heads hood horsepower idle ignition install intake interior introduction leak lights mach 1 manual misfire mods muffler mustang mustang car show mustang gt noise oil paint parts performance power problem problems radio rear end rebuild rims roush s197 sale sct shelby sn95 springs starter steeda supercharger suspension swap throttle body timing tires transmission tune tuner turbo v6 mustang video videos wheels wiring
  1. Mustang II Tech
    I have a 1978 Ford Mustang Cobra II with an 8.8 rear axle that is has a 2.79 gearing. The engine and transmission are both factory original 302 V8 attached to the C4 transmission. Can I use an axle off a 1996 Ford Ranger with an R6 8.8 Limited Slip that has a gearing of 3.73 on my 1978 Ford...
    8.8 cobra interchangeable mustang ii rear axle
  2. 4.6L Tech
    Hey guys I wanted to replace my rear o2 sensors and assumed downstream right meant passenger side when I ordered them from Rockauto. Wrong. Anyways if I just strip off the plastic prongs on the pig tail that don't line up will it still work the same? In other words are the rear o2 sensors...
    interchangeable o2 sensor
  3. Classic Tech
    Hey guys! We were getting ready to start dropping the engine in and were looking at all the related parts when we noticed our drive shaft had a bend in it. So we looked around and found a '68 drive shaft which we were told could be interchangeable. However, the base of the shaft is different...
    '65 '68 drive interchangeable shaft
1-3 of 3 Results
Top