Ford Mustang Forum banner


  1. Coolant Leak - Lines or the Cooler?? Pic

    2005-2010 V6 Mustang Tech
    UPDATE, 03/15/2016: I have successfully replaced the condenser, by myself i might add!! :-) I drained the lines, replaced the condenser, re-vacuumed and re-pressurized it. Good as new! What what!! Thank you to everyone for your help...
  2. 4.6 mustang vacuum line connection with trick flow track heat intake

    4.6L Tech
    I have a 97 4.6 mustang gt with a 2001 PI head swap. I have the 2001 Trick Flow Track Heat upper and lower intake manifold kit. I'm confused as to where my vacuum lines connect and which lines connect to the 3 brass barbs (1 large and 2 small) that come out the passenger side of the upper...
  3. Power drum brakes problem

    Classic Tech
    Hey guys i'm working on my buddies 65 mustang and decided to upgrade to power drum brakes, he will upgrade to disk later. He got the ssbc a28143 1965 FORD MUSTANG SSBC Master Cylinder and Booster Assemblies A28143 - I hooked it all up to the back port at first because i didn't...
  4. 1969 mach 1 transmission line routing

    Classic Tech
    Trying to route the transmission cooling lines on a factory stock 351 Windsor M code. 1969 Mach 1 1.Do the cooling lines run above or below the starter? 2. Above or below the motor mount? 3. Inboard or outboard of the exhaust pipe? I found this thread once before, but can't locate the correct...
  5. whats wrong with my brakes

    5.0L Tech
    Ok so I was just on my way home and someone was stopped right on a corner so I stomped on the breaks but when i did the break pedal almost touched the floor and I slowly rolled to a stop. My breaks were like that the rest of the way home and as i was breaking to pull into my house, the parking...
  6. Eliminating emission controls on 1990 efi 5.0 mustang.

    5.0L Talk
    I have a built 306 that's supercharged. I was wondering what i can do to eliminate all the emission controls other than the 02 sensors. The smog pump is gone, I want to get rid of all the excess vacuum lines, egr valve, and all the electronics on the passenger side of the car under the hood. I...
  7. 1993 Mustang fuel lines

    5.0L Tech
    Hello. I was wondering if anyone could answer this question that I had. I recently had my front frame rails fixed and the guy cut my fuel lines that go from the fuel rail to the ones on the chassis. I was wondering how I could fix this because those lines are very hard to bend back together...
  8. Installiation of windshield wiper lines in a 1968 coupe

    Classic Tech
    I need to replace the rubber lines for the windshield wipers in my 1968 coupe. I have all of the parts but i have to clue where the lines run. Can someone help me out?