Ford Mustang Forum banner

no start only cranking

  1. Another crank/no spark thread

    Classic Tech
    Hi all, 66 coupe, 289 4bbl, auto. Rebuilt engine has a few thousand miles on it, no issues whatsoever. A couple months ago I pulled it in the garage to do a bunch of work and now it won't start. Details: Has an Edelbrock 1406, 4 barrel carb Pertronix billet distributor (electronic)...
  2. 1997 Mustang GT Cranks but wont start.

    4.6L Tech
    Hey I have a 97 Mustang GT that cranks but wont start. It baffles me because i started it drove about half a mile, parked and now it wont start. Ive done a few repairs in the past year so I'm just going to list them off. Replaced the clutch Replaced the catalytic converters changed out the...
  3. Having trouble starting

    2005-2010 V6 Mustang Tech
    Hey guys. I'm brand new to this forum, but stumbled upon during my research on trying to fix my problem. My 06 mustang has been having some trouble the last month or so. A month ago it suddenly died at a gas station. It seemed liked it was out of gas, but I had just filled it up. I had it towed...
  4. 1990 mustang no start

    2.3L Tech
    I have a 1990 mustang lx 2.3l that recently decided to not start. Just recently i replaced the Icm because it was not getting spark. After i replaced that it ran for about a week then once again it will not start. i replaced the fuel pump and the relay for the pump. and i checked the inertia...
  5. Phantom problem back. Data logged video

    4.6L Tech
    Went for a ride about 10 miles. Left car run at idle for 15minutes then went to drive back home and noticed the coolant temp was stuck on cold. Made it he with RPMs hanging with out throttle. That's where the data log videos take over. I did take other one but I must have not saved it. ECT was...
  6. 1988 Mustang GT vert. No spark? help

    5.0L Tech
    hello all im just going to thank you for the help in advanced :bigthumbsup so here is the story. I was bleeding my brakes one night and after finishing i went to test drive my car when it just starts bucking and slowly it just died. still had power and lights just ran crappy n wanted to die if i...
  7. 1984 mustang won't start. Very low voltage at the coil.

    5.0L Tech
    my car is a 1984 Mustang 5.0 it is carbureted and has a manual transmission and duraspark II ignition. I just put an alternator from a 98 mustang on it and now it won't start. It turns over fine, but it is not getting spark. The green/red wire to the coil only gets 1.7 volts with the key on...
  8. 1998 mustang, Sometimes no start, Weird idle

    Classic Tech
    Hi I have a 1998 mustang GT, It will sometimes drive great, but sometimes crank but no start, When it does start it idles weird, at stops the rpm will dip really low and then raise back up to normal. The battery in it is a little smaller than it says to get, however it does read 12.94 volts not...
  9. 2001 Mustang 2.8L will not start

    V6 Tech
    in the title i meant 3.8 Okay well for starters i own a 2001 v6 mustang, i drove it to the store with no problems at all. when i came back and tried to start it it would run hard or run hard and stall and or not start atl all just crank, so i turned it off and walked up to advance auto to get...
  10. 1993 Mustang 2.3 Automatic, turns over no start no spark

    2.3L Tech
    Hello; I have been working on a friends car (1993 mustang 2.3L automatic) off & on for a couple of months now. It has an intermittent no start & stalling while driving. Sometimes there is no spark & sometimes there is spark, but no start. Right now there is no spark. The ICM has been checked 4...
  11. Injector question

    5.0L Tech
    I have an 87 5.0L engine, but I bought some 19lbs injectors from another mustang owner. I noticed that they are slightly different, my originals had a single hole at the bottom and the ones I bought (and are currently installed on the 87) had 4 micro holes at the bottom. The part numbers are...
  12. 2000 GT not starting, just cranking

    4.6L Tech
    I went to start my car this morning and when I tried to start it it just continues to crank and not turn over. I can start it with starting fluid and it will stay running after that however, if I shut it off and try to start it again it won't start just crank. Visually everything looks fine...
Top