Ford Mustang Forum banner

oil pressure sending unit

  1. 302 No Oil Pressure Reading

    Classic Tech
    I replaced my oil sending unit on my 302 but when the engine is running the gauge doesn't move. I have grounded the wire and the gauge pegs so I know thats not the problem and since I have driven it plenty of times I know the engine is getting oil. Anything else that could be causing this...
  2. 1965 oil pressure and water temp sending unit locations?

    Classic Tech
    I'm rewiring my 1965 Mustang six cylinder coupe with the american autowire kit and need to connect wires to the oil pressure sender, and water temperature sender. I found the oil pressure sending unit, but can't for the life of me figure out how a wire is supposed to connect to it. I attached...
  3. Need help identifying oil cooler adapter mystery port

    SVT Cobra Tech
    My 1999 Cobra has started leaking oil and a preliminary trace has led me to the area of the oil cooler adapter. If I were to hazard a guess, it looks like the oil pressure sending unit might be the culprit; however, it's also possible it's coming from the "port" located directly below the...
  4. Oil Pressure Gauge Fluctuating

    4.6L Tech
    I have a 2000 Mustang GT 5-spd with about 152,000 miles. Just yesterday I noticed the oil pressure gauge was fluctuating when at idle or my clutch was in. It would go from normal (little more than half way) back to 0. Once I start to drive it goes back up to normal. I noticed this only happens...
  5. 70 mach 1 Oil pressure Sending Unit

    Classic Tech
    Posting again.. Not sure what happened to my previous?? Bewbie here.. On other Forums.. Not getting much feedback.. 70 mach 351 C. Want to install an electrical oil pressure & Temp gauge(autometer) Mach currently has IL's Located the temp sender..easy..on the water pump...
  6. 1965 Mustang oil light malfunction

    Classic Tech
    Well, i have a 1965 mustang and i am trying to figure out why the oil light wont turn off, i just put more oil in it this morning, and the oil light stayed off for a bit, then it turned back on, any ideas on what could be going on? i plan to replace the pressure sensor too. The engine it self...
  7. New 1988 Mustang Gt owner

    Introductions
    Hi, My name is Michael, I recently bought a 1988 Mustang Gt 5.0L Convertible, with 73,000 miles on all parts. Brang new paint job, clutch replacement, new tranny, and some basic mods. The original owner is a good friends brother in law who just bought a 05' Viper, so his wife made him get rid of...
  8. 1988 Mustang GT Oil Pressure Sending Unit Location

    5.0L Tech
    I was wondering where i could find the oil pressure sending unit on an 88 5.0. I'm doing an oil change and i would also like to clean the connector on the oil pressure sending unit. Just one problem, I don't know where it is. Any help would be appriciatied.:so
Top