Ford Mustang Forum banner

oxygen

  1. 2005-2010 Mustang GT Tech
    here is my problem, i recently had a problem with my mustang 06 4.6 GT some problems with the transmission and solenoid codes, they made me to remplace a lot of unnecessary things and expensive ones, however at the end i ran out of money, i bought a new PCM, and bum i fixed my self, at the end...
  2. 2005-2010 Mustang GT Tech
    Hey everyone. So recently my o2 sensor went out and threw a code P2196, and i cleared it with my tuner. Its been running sloppy, a choppy auto choke, high idle, etc.So i have a couple questions, btw its on a 2006 gt. So first, what o2 sensor out of the four is it? i heard it was the bank 2...
  3. V6 Tech
    I have a 2002 3.8 Mustang. I am in the process of putting headers and getting the exhaust re done. was wondering the best was to either have the O2 sensors function and or bypass them. I got dual exhaust on it right now that will be running duals. i have the headers and new mufflers. the...
  4. 4.6L Tech
    Which o2 sensors run best in these cars? NTK?Motorcraft? Anyone know a better brand out there?
  5. 2005-2010 V6 Mustang Tech
    My check engine light came on and my OBD II said it was an Oxygen sensor heater circuit malfunction. I replaced the sensor and the light came back on. I ran the test again and it said Oxygen sensor stuck rich. Did i install it wrong or do i have a bigger problem.
  6. 5.0L Tech
    We've picked up a 1989 Mustang with a 5.0L engine and 5-speed transmission. Unfortunately, there's no wiring harness from the oxygen sensors into the main harness. We need the 8-pin connector schematic for how it connects into the main harness. We've been scouring forums and all we've been...
  7. 5.0L Tech
    Hi, After jacking up my car to replace the tie rods, I noticed the harness that connects the o2 sensors to the harness had been dangling and the connector on the harness side had been damaged beyond repair. I went to the Junkyard and pulled the connector from the only 5.0 mustang they had...
Top