Ford Mustang Forum banner

pan

  1. 1978 Mustang II complete floor pan swap with 1976 Mustang II. Possible?

    Mustang II Tech
    I am restoring a 78 Mustang II. The exterior, including the paint is really good, but there are rust holes from the front to the rear on the inside floor. I mean one of them is over 1 foot long and 2-3 inches wide so that you can see the frame. The frame isn't even touching on the driver side...
  2. Removing oil pan 2002 3.8

    V6 Tech
    My girls oil pan for her mustang cracked and im having a hell of a time getting it out. i pulled the motor mounts and lifted the engine via engine hoist, but i cant get the oil pan to slide out. any tips besides dropping the k bar? i really need to get it done by tomorrow so it would be nice to...
  3. 351w oil pan problem

    Classic Tech
    i have a 351w front sump im building up thats going into a 66 mustang and i just purchase a new pickup tube for the new oil pump. but when i bolted it in and tried to put the pan on, the pan would hit the new pickup tube and leave a maybe 1/4 in. gap between oil pan and block. the oil pump i...
  4. Too much transmission fluid or leak?

    V6 Tech
    Car: 1999 Ford Mustang; automatic trans; 3.8L I just replaced the transmission pan on my mustang, and filled it with 9 quarts of transmission fluid (I didnt drain the toque converter because I didn't change the fluid because it was bad, only because I got a new pan) After the 9th quart, I seen...
  5. 1994 Mustang Transmission falls out of gear. Why?

    V6 Tech
    I have a 94 mustang and I just had a pan put on it yesterday. This being said, I know it is full of fluid. When i drive the car it shifts fine but after about 40 miles it will just fall out of gear into neutral. I play with the throttle and it will kick back in gear. I park it, get in it a few...
Top