Ford Mustang Forum banner

repair

  1. 2005-2010 V6 Mustang Tech
    Hello, I'm having trouble with my S197 2006 V6 mustang as all four O2 sensors are stuck on rich and coupled with this is the fact that it runs horribly and spews unburned gas and carbon particles from both exhaust pipes (aftermarket). I've replaced the spark plugs, both upstream O2 sensors...
  2. V6 Tech
    I bought a nice 2000 mustang but the radio does not get power. The fuses are fine. The story is that the last owner plugged in a tire pump to the cigarette lighter and it shorted and caused to cigarette lighter to break and the radio soon after. Not sure what the problem is and I hope the head...
  3. 2005-2010 Mustang Talk
    I just bought a 06 mustang to fix up and i have put it mostly together but the trunk panels are unhooked and wont stick i dont know what to buy to hook it back to the bolt if you can please direct me to a url that will sell the part to me Thanks
  4. News
    Oil leaks, coolant leaks, transmission fluid leaks...they all have one thing in common. No one wants to see them, or the puddle of fluid they leave in the driveway. A blown gasket is one of the most common causes for these leaks, but how can you tell which gasket has blown — and, once you figure...
  5. 4.6L Tech
    I hope I am posting this in the correct area. I have had this account for a long time but I have only used it a few times so I am not experienced with it. I searched for a while on the different engine swap forums and I couldn't find the exact thing I was looking for so I apologize in advance if...
  6. Show & Shine
    Hey y'all, First time mustang owner. I'll keep this short. I was in a parking garage today and caught the left front "wheel sill" of my 2006 V6 Pony Package Mustang on a concrete pillar. There are scratches down to the metal, past the primer. From some basic google searches, it seems as if I am...
  7. Classic Tech
    Today I found out that my turn signals on both the left and right side of my Mustang will turn on, but will not blink. I've checked the emergency flashers to make sure that they still blinked (they did) and the cause was not the turn signal flasher. I'm wondering what else could be the reason...
  8. Classic Talk
    I bought a 1965 fastback GT clone with a 289 HiPo 4/M for $24,000. plus $500 for delivery... I just put another $4000 to redo the head gaskets, carb gaskets, replace clutch, rear trans seal, diff seal, coolant hose kit, steering bushing kit. and change all fluids. so my out the door cost...
  9. V6 Talk
    I was driving down main street a few days ago and a loud bang resonated from my undercarriage, I pulled over and I found this beautiful looking hole spewing oil everywhere. Oil pressure is zero and my transmission is still functional as far as i can tell, so I'm wondering if anyone can tell me...
  10. V6 Talk
    Greetings, my name is Dillon. My girlfriend Jessica and I are having some car troubles. One problem after another it seems. First an exhaust leak which took two visits to the muffler shop to repair. Next came a break pad falling off at a stop light. Now currently both head gaskets are leaking...
  11. V6 Tech
    After A diagnoses, and code check for my 1999 V6 Mustang I learned that I have a few more problem than i thought. The codes that were found consisted of: P1131 Lack of bank1 02 transitions- lean ECM detected bank1 02 at its leanlimit probable cause -Misfire Bank one -Vacuum Leak Affecting Bank...
  12. 2011-2014 Mustang Talk
    Ford currently has a shortage of sheet metal parts, at least for the 2011-2014 models. I've been waiting over 3 weeks for a new door to come in and they bumped it back a second time for another delay of at least a week... Ford customer service was absolutely useless...they recommended that the...
  13. 2011 - 2014 Mustang GT Tech
    Hi all, I have a 2014 Mustang GT that I bought in July. It has about 9100 miles on it. I took it out this morning and noticed it was running a bit rough out on the highway. It was shuddering/choppy when accelerating and backfiring when I let off of the accelerator. Turned around and took it...
  14. Classic Tech
    Hello all, New to the forums here and before anyone says "do it yourself", I am still learning the basics of auto work/maintenance. I own a 1967 Mustang GT-A model that needs, at the very least, a power steering pump rebuild, or at the most a new one all together. I don't have the...
  15. Introductions
    IThe camshaft journal got scratched I was wondering if it was still repairable or if it's done for good
  16. 4.6L Tech
    At about 0-20 e-brake light is turns on then at 20 turns off but if you step on it the light turns on again. My e-brake is disengaged. Brake fluid is fine. I notice a slight smell of something burnt towards the rear driver side tire. Would this mean that my brake is engaged and stuck? If so how...
  17. 2005-2010 Mustang GT Tech
    2005 GT with " Broken Lift Arms " I think they're called on my Convertible Top Hello. This is my first post . I just bought a 2005 GT knowing that there was an issue with the top folding all the way down. The repairman showed me where the 2 arms that lift the top are broken. Ford gave me a 2...
  18. 4.6L Tech
    A few months ago someone ran there shopping cart into my car and i was wondering if the panel could be repaired or if i have to replace the whole panel. Thanks for the help
  19. 5.0L Tech
    I own a foxbody and my clutch isn't disengaging completely. I tore the quadrant apart and it's not broken. All the teeth are perfect and in fact there isn't even a groove wore into the plastic.The clutch cable is brand new (was installed just before winter) and looking at the throwout bearing...
  20. 2005-2010 V6 Mustang Tech
    Ok, I am going to try and explain this the best I can. I have a 2005 V6 Manual Trans. I JUST got this thing back from a local shop that did the timing set for me. The shop owner told me he looked over my clutch since they had to pull the entire motor to do this job, and said it looked good, and...
Top