Ford Mustang Forum banner


  1. Video - Rolling 4 Fenders on 2002 Mustang

    Wheels and Tires
    Used the Eastwood Fender Roller to roll both front fenders and the quarter panels on this 2002 Mustang. Turned out great. This is the video. Fender Roller DIY - Rolling Fenders and Quarter Panels on a Mustang with an Eastwood Fender Roller - YouTube
  2. Distributor help for my 1968 Mustang

    Classic Tech
    Just picked up a rebuilt 95 5.0 ho motor out of this dudes bronco he was parting. Anyways got the engine in my 68 coupe finally started it today , runs good except the high idle problem prolly my carburetor not a big deal at the moment but my question is what distributor would you guys recommend...
  3. 1966 Mustang Rocker Arm choices

    Classic Tech
    Hi everyone, I have a 66 mustang with a 289 v8 and c4 trans. I just ordered new heads and camshaft/lifters from Edelbrock. The heads come complete with valves and springs, but not rocker arms. So I know I want roller rocker arms. But as for performance, whats the difference between...
  4. roller motor?

    5.0L Tech
    hey so i have a 86 block so it isnt a roller cam and stuff but i do have a 92 roller motor in the garage and i was wondering if i put the roller cam and lifter and rockers and the other heads on my block if it will up my horsepower enough to notice? i read in a mustang book that my block is...
  5. Possible roller conversion

    Classic Tech
    Hey guys - I posted this same question over in the 5.0 tech page too, but wanted some exposure over here to see if you guys had any ideas on this one before I decide to spend any money. Basically the short version of this is I was thinking about converting my 5.0 engine I dropped in to my '65...
  6. 5.0 block possible conversion

    5.0L Tech
    Hey guys - I need some help, as I'm lost right now. My application is a 5.0 block in a '65 mustang, my question is just concerning the block. Here's where I'm at. I got a little too curious about a head swap the other night and wanted to ID what all I have. I need to swap out gaskets and...
  7. 5.0 motor component questions

    5.0L Tech
    Hey guys...I've got a few things I need help clarifying (to be honest I'm just a little lost from everything I've researched). So here goes (please be nice): Basically, I've got a '65 mustang that I swapped a 5.0 into. I got it (the motor) from a guy that builds motors and race cars and one...
  8. 1.8:1 bolt-on Roller Rockers

    V6 Tech
    I really want to buy some from "Tom Morana V6 Racing"! Has anyone ever used these or had any problems with these rockers? They claim to add 15-18HP! Not too bad for $350. A little pricey but relatively easy install... So can any give me any info or experience with the 1.8 roller rockers from...