Ford Mustang Forum banner
s197
1-20 of 122 Results
Advanced
  1. 2011 - 2014 Mustang GT Tech
    So I've had an issue that has been getting worse and worse, for some reason my tuner told me I have low oil press at high rpm causing the cams to revert on shifts and it's almost like hitting the limiter and then shifting and then spmetimes only when into specific gears(automatic) trans is good...
  2. 2011-2014 Mustang Talk
    I’m looking at lowering my 2013 mustang gt, and I’m wondering what springs have the best ride quality. It is my daily driver so I want something comfortable and not to low. When I lowering it do I need to pair it with shocks and dampers, and if so what kind
  3. 2011 - 2014 Mustang GT Tech
    Sooooo I need to replace the part but I can’t figure out how to get access to the sensor it has catalytic converter still and there is limited space to even try to break the sensor free . I tried but the damn thing is too stubborn to even loosen up and with the limited space it’s just not...
  4. 2011 - 2014 V6 Mustang Tech
    Currently looking under the hood of my 2012 v6 base model with a manual transmission and I noticed the only pulleys I see on my motor, are ac condenser, water pump, idler, alternator and the balancer, where is the power steering and where is the resvoir I see on some cars, it’s near the radiator...
  5. 2011 - 2014 V6 Mustang Tech
    Hey everyone I’ve posted recently about my 2012 v6 car that I picked up that had a p0430 code with a slight mis, changed the plugs and an o2 sensor, I just changed the cats today, turns out the cats were toast, there was nothing left to them inside, but my car is still running with a slight mis...
  6. Purchasing, or Ordering-A BRAND NEW- Mustang
    Hi, I'm looking into get a mustang GT as my next car, its one of the best options compared to the 1SS Camaro and the Scat Pack challenger, but I'd like to know how much I really should be paying. I don't want to be ripped off because of covid shutting down factories, I know used car prices...
  7. 2005-2010 Mustang GT Tech
    Hello I’m having trouble w this could yall help, I have a 2006 Mustang GT and I recently had to replace the whole differential, I got the same gear ratio and all that but the pinion flange on the new used differential seems to be a aftermarket one because it’s short and the driveshaft can’t...
  8. 2005-2010 V6 Mustang Tech
    Hi there. I am driving a 2005 v6 Mustang in Japan. Sorry if my English is wrong. About a month ago, I was riding in my car on a rainy day when I noticed that the left side of blinkers were always on, both front and rear. I turned off the engine and it kept going, so I disconnected the battery...
  9. 2011-2014 Mustang Talk
    I'm the 3rd owner of a 2006 Mustang GT, currently a little over 118,000 miles, bought it at around 92,000 miles, automatic transmission (yea yea yea I know). Sometimes, not always, when shifting to reverse, it lags for a second, then shifts rough/fairly hard into reverse. Sometimes it will also...
  10. 2005-2010 Mustang Talk
    Good afternoon, I recently bought a 2007 mustang gt with about 103k miles. Didn’t bother getting a carfax at the time because it was a really cheap car but later on found someone on eBay doing them for 10 dollars so figured why not lol. Well I noticed it says “short block replaced” on the...
  11. 2005-2010 Mustang GT Tech
    Hello everyone, I was wondering if anyone can help me with the issue I am having with my 08 GT. ***NEW starter, NEW Alternator, NEW Ignition Switch. Basically my car won't start, all fuses and relay's are good, when i turn the key my PATS is off so key should be good, F21 in SJB is getting...
  12. 2005-2010 Mustang GT Tech
    Hi community, I finally decided to open up a new thread to make use of everybody's knowledge, advise and experiences. I already read trough Dingo7222's thread which sounded exactly like the problem I have with my car. But, I checked the motor mounts and especially the spacing of the steering...
  13. 2005-2010 Mustang GT Tech
    Why is my car feeling hesitant at times? I am hoping someone here has had similar issues, and can weigh in on this. Just a quick run through of all the mods I have: 1. Pypes Axle Back Bomb Exhaust 2. Ford Performance 3.73 rear end 3. Ford Performance Traction-LOK Limited Slip Differential w/...
  14. 2005-2010 Mustang Talk
    Hey everyone, I recently had a check engine light for catalytic converters . I didn't think it was serious until about a couple of days later the car started acting weird . Like I'd press the gas and it wouldn't accelerate. It eventually got so bad i had to stop driving . the car would stall on...
  15. 2011 - 2014 Mustang GT Tech
    Hi Everyone, I have a 2011 Mustang 5.0 that was ordered new and delivered in Fall of 2010. It's probably part of the first batch off the line. As of right now, every suspension component in the car has swapped out with the exception of the front lower control arm. I know that the 2011 models...
  16. 2005-2010 Mustang GT Tech
    Noise on cold startup - RESOLVED !! CAM PHASER VVT Any ideas what this noise could be @ 4 seconds in the video ? The earlier noise is the e brake It only happens when the engine is cold(summer 80 degrees+ and winter) It happens for about 1-2 seconds after it starts up. When the engine...
  17. 2011 - 2014 Mustang GT Tech
    Firstly, has anyone had a lot of experience dealing with the first generations of the MT82 since they released in 2011? I am curious if mine being a 2012 model would be a first generation MT82 with all of its issues and quirks, or a second generation? I was just reading up on this transmisison...
  18. 2011 - 2014 Mustang GT Tech
    So I didn't like how my s197 can factory with LED Tailights but HID headlights and incandescence bulbs for everything else, so I upgraded all the incandescence bulbs to LED. Last week I replaced all the 194's with LED, Marker Lights & map lights and there was no problems. Yesterday I replaced...
  19. 2005-2010 Mustang GT Tech
    Alright I have been chasing the cause of this noise since I got the car 5 years ago. The noise started showing up when I would be turning right with the car in 3rd gear at about 1800rpm. If I were to push the clutch in, the noise would go away. If I revved the engine to ~1800 rpm in neutral...
  20. 2011 - 2014 Mustang GT Tech
    I have a 2013 GT with GT500 axlebacks, and recently Ive had my resonators removed at a local shop and I was not a fan of the new sound. The idle sounds super quiet and at high RPM the exhaust has a very metallic, tinny sound, almost like a rattling tin can. I took a look at where the resonator...
1-20 of 122 Results
Top