Ford Mustang Forum banner

sensor

  1. 2005-2010 Mustang GT Tech
    Hi folks, I had an 06 Mustang V6 for a bunch of years, and in May, found myself the 09 GT I'd been longing for. 31k miles, everything works perfectly. Terrific car. Today is the first issue though: I got about a couple hundred yards down the road and the low oil pressure warning goes off...
  2. 2011-2014 Mustang Talk
    The car is tuned with the bama 93 race tune, I data logged and it shows the vvexb1a bank 1 sensor 1 o2 sensor stuck at .07 . I have changed the sensor, it seems to be running better but I data logged again and the sensor is still reading .07 . Any ideas what could be the cause of this?
  3. 2011 - 2014 Mustang GT Tech
    Hello everyone! First time on the forum. I was hoping to get an answer for an odd question. I have the engine code that says i need a new o ring on my crankshaft position sensor. I was going to take it out and just find an o ring that fits correctly. Now will i get issues if i dont use the exact...
  4. 4.6L Tech
    What is the sensor I have circled in red in both photos attached? Is it the Engine Coolant Temp Sensor? Also the white part where it plugs in spins freely, is it supposed to spin like that? Like it's loose from the brass threaded part.
  5. 2011 - 2014 V6 Mustang Tech
    Hi, this is my first post ever so please don't be mad if my post is in the wrong place :). I recently bought an oil temperature gauge for my 2012 V6 with the idea to place the sensor into the oil pan by drilling a hole in it. I don't really feel comfortable with the idea anymore, because I don't...
  6. 2005-2010 Mustang GT Tech
    here is my problem, i recently had a problem with my mustang 06 4.6 GT some problems with the transmission and solenoid codes, they made me to remplace a lot of unnecessary things and expensive ones, however at the end i ran out of money, i bought a new PCM, and bum i fixed my self, at the end...
  7. 2005-2010 Mustang GT Tech
    Hey everyone. So recently my o2 sensor went out and threw a code P2196, and i cleared it with my tuner. Its been running sloppy, a choppy auto choke, high idle, etc.So i have a couple questions, btw its on a 2006 gt. So first, what o2 sensor out of the four is it? i heard it was the bank 2...
  8. Classic Tech
    Whenever I started the car the temperature gauge would go off the charts hot. I replaced the temperature sensor and it still did the same thing. I put teflon tape around the threads still the same thing. It has and aftermarket edelbrock performer intake if that is important
  9. 2011-2014 Mustang Talk
    I have a 2012 5.0 and just bought a used set of 20" Vossen cv3's. The person I bought them from had an infiniti G37 and left his stock tpms sensors in the wheels, are these in any way compatible with our mustangs and if so what kind of resetting tool would work for it. or do i need to buy a new...
  10. 4.6L Tech
    Hey guys, First post here and would appreciate all the help I can get. I have a 1998 4.6L V8 Mustang GT. It has all of the classic symptoms of a faulty cam shaft position sensor. In fact, that's also what the computer has coded as well. I have heard it is not a hard fix to replace the...
  11. 2.3L Tech
    So I have heard recently heard of something called a Knock Sensor on the 2.3L engines. I also heard that they hamper performance significantly. What is a knock sensor and what does it do? Does it really decrease performance? If so can it me removed without many/any negative effects? Where is it...
  12. 5.0L Tech
    Ok here we go. I had no operational temp gauge on my 94 GT. I replaced the temp sending unit which fixed that issue, now I have a new one. It's overheating, BAD. The fan isn't even kicking on. I have a new ECT sensor which I think may help, but I don't know for sure. I also have a new...
  13. Classic Tech
    So after driving around today my oil light decides to come on even though my oild pressure gauge is showing normal readings. I noticed that it flickers when i drive on uneven road and turns off when i go over a speed bump or a pothole, or when im on and incline. So my guess is that the sensor...
  14. 5.0L Tech
    Start off give you some info on the car it's a 1989 ford mustang started as a 2.3 and swap it for a 5.0 connecting rod bolt broke and cracked the block got a used engine out of a 97 explorer with gt40p heads fake cobra intake some upgrades from the 5.0 stock checked the crankshaft end play...
  15. Audio, Video, Navigation & Alarms
    I really could use any help. My newly purchased cobra has an aftermarket standard avital alarm system that will not stop going off. About every 15 min it goes off every time. Ive played with the shock sensor but it continues to go off no matter what! :frustrated:
  16. 2011 - 2014 Mustang GT Tech
    Hey Guys and Girls, Here's a tag on what was going on. http://www.allfordmustangs.com/forums/2011-mustang-gt-tech/322745-update-tag-2011-2012-gt-power-loss-cel-flashes.html Basically my 12 GT stalls and loss power at 60mph 4k rpm on 4th gear. CEL flashes and in about 20 sec it let go and...
  17. 2005-2010 Mustang GT Tech
    Hello, I do not have any catalytic converters on my car and am trying to find away around have to get cats. I was wondering if there are 02 sensor simulators that will work on a 05 GT. Any advice or help is appreciated. Thanks!
  18. V6 Tech
    About a week ago my mustang started making a chirping sound from the engine, through reading some threads here at AFM and a few videos from youtube I have come to the conclusion that my camshaft sensor and/or synchronizer is starting to go. 1. What would be the consequences of not fixing it in...
  19. V6 Tech
    I have a 1999 Mustang, with the 3.8 liter V6, I replaced the thermostat, radiator, and hoses. I think that fixed my leak..but now the temperature gauge does not work. There is a plug just next to the thermostat housing, is that the sensor for the water temperature, the wires on it were a little...
  20. 4.6L Tech
    Which o2 sensors run best in these cars? NTK?Motorcraft? Anyone know a better brand out there?
Top