Ford Mustang Forum banner


  1. 97 mustang gt clutch sliping?

    4.6L Tech
    i have a 97 mustang gt that is having problem with the clutch slippig i recently replaced the transmisson and throwout and pilot bearing and the clutch cable and had the flywheel resurfaced and now the car is hard going into and out of gear and is losing a lot of power with a lot of smoke coming...
  2. Clutch/ flywheel or throw out problem... Which one do I have?

    Classic Tech
    Hello everyone , I recently installed a RAM flywheel in my 65 w/ 289 engine with 4 speed top loader and I'm having issues. First time I ever changed a flywheel and I'm sure somewhere something went wrong. After re-installing everything I hear a rubbing sound as in something is scrapping against...
  3. 1997 GT Clutch Adjustment

    4.6L Tech
    I recently changed my clutch and throwout bearing. On my first test drive afterwards, I noticed a pulsing squeak at low speeds. It is synchronized with the speed of the car, but goes away if I disengage the clutch. I just changed the brakes so that's not it. It sounds like it is coming from the...
  4. release/throwout bearing spins constantly 2003 Mustang GT

    4.6L Tech
    NEW clutch, p.plate, release and pilot bearings, ballstud and lever installed. Clutch release/throwout bearing spins constantly and has no clearance between the bearing contact surface and the pressure plate fingers. Cable and lever move freely but when cable is connected to the arm it pulls...
  5. Quadrant steeda double hook quadrant does it help

    4.6L Tech
    So my throw out bearing is still squealing after puttin in a new one but if you barley touch the clutch pedal it quits..My car has about 90,000 miles on it and its had some hard shifts is it possilbe that putting a new quadrant in will stop this...
  6. CLUTCH and THROWOUT bearing trouble

    4.6L Tech
    so here's what's going on with my car...Ive put a new clutch in my car and my throwout bearing has a terrible chirp ive replaced it 3 times with aftermarket and factory throwout bearing with the same result. But if i put the slightest bit of pressure on the pedal just the weight of my foot it...