Ford Mustang Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 29 Results
  1. V6 Talk
    Had transmission serviced again at over 200,000, has always been maintained. Ford said not to do this again at this mileage, that it would cause more damage than good. Trans has worked fine, until a few weeks later - trans seemed to not shift, as I stepped on gas the tach would seem to rise in...
  2. 5.0L Talk
    First post and dont wanna be that guy asking the same questions on previous Threads... But would a Viper alarm be overkill on my 5.0? I cherish it but realize there are functions the alarm is capable of that my car prly wont support. Auto start etc... Its the five speed so not sure if its...
  3. 5.0L Tech
    Hi, I have a rattle in the c5 trans of my 86 auto. It is a rattle somewhere near the front of the trans- and gets louder and rattles more under load and acceleration- but virtually disappears when cruising along in top gear- appears that when you place car in drive with engine going- then...
  4. 5.0L Tech
    Ok guys and gals, Heres what I have. 1948 ford F3 truck all mustang underneath. 1991 5.0 HO efi to carb swap already done. 94 AODE/W trans installed. 97 mustang rear axle. 2005 Crown vic front suspension.(still ford ;) ) Heres my issue. How do I control the transmission? I already know about...
  5. Classic Tech
    Looking for some input. We are putting a 87 model 302 in our 66 coupe, just had a 70 model c4 rebuilt to go in it. The problem is I don't know what torque converter to use I have a 26 spline input shaft and the bolt space on the flexplate is 11.5. Any help would be appreciated.
  6. 5.0L Tech
    Hi guys, new here, but not new to Fords or projects. Long story short, my daily/project at the moment is a 2006 Focus ST, cleanly modified, and even installed a GT28R setup running 12psi. But that's beside the point. I was referred to this forum by a buddy who told me you guys all know your...
  7. 2011-2014 Mustang Talk
    Not available yet but hopefully soon. First read about it on Vorshlag's 2011 Mustang blog and there is also some interesting discussion over on the Boss forum. Whiteline Transmission Bushing Insert
  8. Classic Talk
    Hey guys, I have exhausted the search function and my research really hasn't helped much so I am hoping PaulS or Veronica or one of you other awesome people can help out with some answers or advice on this one. I bought this early convertible with factory 260 and factory manual trans many...
  9. 5.0L Tech
    My 1989 Mustang GT with AOD transmission will not shift past 2nd gear. I had my heater core replaced by an off duty mechanic this morning. The guy really does seem to know what he is doing and works in a shop building pro street cars during the week. After leaving, my girlfriend, who was...
  10. 2.3L Tech
    Went to the junkyard today to get a few parts for my recently purchased mustang. While there I could find only one other fox in the yard so i got what I needed and moved on. Now to the question at hand the auto trans is bad in my car and am looking to swap for a 5sp and I know I have to source...
  11. 2005-2010 Mustang Talk
    I need help and I've searched the internet and not finding anything that helps me. I have a 2006 V6 5 speed manual and the clutch on it doesn't release until its ALL the way to the floor. Other times when I'm shifting it won't go in gear Ex- taking off heavily and shifting from 1 to 2 the...
  12. V6 Talk
    Getting a newer engine put in my stang, Will my old transmission hold up?? will it need replacing??
  13. 2.3L Tech
    I was wondering if there is anyone in or near the Omaha/Metro area that has a auto transmission for a 2.3l lx that they are willing to sell? not sure if this is even that right place to post this thread. thank you.
  14. 5.0L Tech
    Hi, i have a 90 mustang 5.0 with the AOD trans and if you drive it in overdrive it shifts at like 2,000 rpm and is in fourth at a fairly low speed is this normal? Its a little better in straight drive but it still shifts into third fairly quickly and if you get on it, it will stay in third and...
  15. 5.0L Tech
    Hello. Recently I have been having some difficulties shifting, especially into first. When I go to take off from a dead stop at a light the shifter will pop out, make a loud bang noise, and scares the hell out of my passengers. It started out as taking one or two tries to put it into gear...
  16. 5.0L Tech
    ok here is what i got 88 mustang gt 5.0 5 speed and the starter will make a whinning noise once and awhile when trying to start it and when car is running it will make a squeeking or rubing noise from like bell housing but if i hit brakes good when driving noise will stop
  17. 5.0L Tech
    Hey, So this is for you T5 masters, I rebuilt my T5 not even a year ago and ever since i rebuilt it its been making gear noise. At first I wasnt to worried about it but now I just find it irritating. I must admit I did a full rebuild with new gears and what not. Only thing is I didnt replace...
  18. V6 Tech
    Hey i want to swap from a automatic transmission to an manual Transmission in my 2000 Ford Mustang 3.8L, is it possible and what all would i need?
  19. 5.0L Talk
    Hi, does anyone know if you can buy a manual valve body for an AOD transmission. I installed a transgo shift kit in my car and am not really happy with it. and would I need to change my shifter as well? thanks.
  20. 2005-2010 Mustang Talk
    i have a 2006 mustang v6 again i had a 5.0 put in and i think a t5 transmission but their gone now back to straight stock 4.0 v6 just wondering what some opinons would be for my next engine i was thinking eather 4.6 or back to 5.0 or if the opratunity came up maybe a cobra engine if i could...
1-20 of 29 Results