Search Results for ‘wiring issue’

Okay I bought a 05 roush 5 speed 4.6 about 2 maybe 3 weeks ago not it was wrecked in the front in of course one of the first things I fixed everything else seemed amazing other then a fan not wanting to kick on but heck that’s fixed now too anywho it’s back to normal other then some paint work...

Good people, I need some help as I am not as wire savvy as I would like to be. 97 Mustang GT 4.6 SOHC It will start/run strong as long as it wants, it could be a day or it could be 3 months. Every now and then, when I put the key in and turn the power on I won't even get dash lights or I will...

After recently purchasing my 2015 GT, I discovered that the previous owner did some fudgery with the output speed sensor on my transmission (See photo below). I get the sense that these three butt connectors are mixed up, since my datalog shows 0 RPM's, no matter the speed. I also have a feeling...

Hi there, Need help with wiring. We are trying to fit 90 harness with the 86 dash. Tips or opinions greatly appreciated Thanks

I'm Having a problem with blown headlights in my 65 coupe. Every time I rev the engine my interior lights get brighter, and my headlights will get brighter and blow, on high or low beam it doesn't matter which one. My set up is as follows: stock 65 mustang wiring harness under the hood, halogen...

I have a 1968 mustang. The headlights originally did not work but I replaced the headlight switch after reading numerous reports that it goes bad and it is most likely the cause. Now the driver side headlight works but the passenger side headlight doesnt work. Does anyone have any ideas on how...

I recently got my car back from paint. When I got it back it wasnt running well anymore and was difficult to get it to start. We went ahead and swapped out the points distributor for a duraspark distributor after this the car was running better then ever for about a week or two. So when I tried...

First I would like to say I just joined this forum after reading all the awesome posts and looks like there may be a common ground here to help each other. I am proud to be here and thanks for letting me join! Now on to the issue at hand... I purchased this 89 Mustang the other day and one of...

Help, I have a 1988 5.0 w/man transmission. I am getting no pulse signal to the coil. Have checked and am getting power to both sides. Have changed coil and wires, changed distrubitor with module, both new and set-up together.. Have checked different wiring diagrams and found two different...

So im not getting gas to carburetor because the fuel pump is not getting any power. i went back to the fuel relay and two out of the four wires have power and im not sure where those two wires go to fix them. the wires are pink with a black stripe and orange with a black stripe. The car had a...

Just took my 66 out for the first time this year. Went about 2 miles with turn signals working fine then right before I got back home they stopped working. The right signal just stays constant and the left wont work at all and I noticed the amp gauge flickers when I use both of them which seemed...

I have a 1966 Mustang coupe with a 302, C4 automatic transmission, air conditioning, power steering, power brakes. I recently swapped over from a 65-amp externally regulated alternator to a 3G internally regulated 95-amp alternator from PA Performance. I have an aluminum radiator with a Derale...

I have a 1988 Ford Mustang GT 5.0 and I'm trying to figure out the wiring for my alternator pig tails there are two of them and I am missing the smaller one with three pins. How can I wire a stock alternator back up to the pigtails? Any suggestions would greatly be appricated

When restoring my 1967 coupe, we eventually replaced the alternator as well as the battery. The alternator that we received had different wire hookups than the original... Coming out of the harness there are 4 wires, a thick black wire, a thick blue wire, a thin black wire and a thin black wire...

My 66 Mustang will turn over but will not STOP turning over. I think at this point I have probably cooked the starter (not sure because I'm not brave enough to try again). Could it be the solenoid? It's a 6 cyl.

I'm currently trying to install a set of reverse glow gauges for my 1997 v6 mustang similar to these 96-97 98 FORD MUSTANG V6 3.8 120mph 7k GLOW GAUGES EURO: eBay Motors (item 180460077940 end time Aug-20-10 17:50:49 PDT) The fuel and battery sides slide on perfectly, and I have no problems...

i have a 1989 mustang 5.0 that i need some wiring help on. i am in the process of putting the engine back together aka already together just need help on the wiring. i removed the ac cruise control and smog pump and was wondering how many loose plugs i should have laying around after i get...

Just got into the fuel presssure problem on my Mustang, first thing was getting into the trunk to see whats going on. What we found is scarey. There is a extention cord wire..going from the fuel pump threw the trunk and interior to the fuse box. We need to know how to fix this hack job. anyone...

My fuse box seems to be corroded in the clips. the wiper blades, radio, heater, interior light, horn, and dash light dont work what should i do. my last resort is buying a $600 wire harness but i wud like to make it all work for cheaper and easier. thank you

I installed a new sound system in the car. The wiring kit that is used to connect the factory harness to the new system had 2 cables for illumination (1 solid orange wire, and 1 orange wire with a black stripe). As with most kits, you typically connect these 2 wires to the one orang wire with...