Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
295 Posts
Discussion Starter · #1 ·
has anyone swapped out the stock cams for aftermarket cams? i am thinking about doing this to my cobra. i was just wondering if anyone has done this yet. i have already installed 2.8 pulley, reflashed the computer, changed all idler pulleys, aux. idler pulley, mass air meter,flowmasters,steeda shifter.if anyone has changed the stock cams, did you also change valve springs or just reuse the stock springs.

any feedback would be greatly appreciated.thanks.
 

·
Registered
Joined
·
579 Posts
Someone local to me in Aug. put them in. He will tell you that they are not worth the money in the parts or the 2 days putting them in. He only gained 12whp on top and lost torque till 3000 rpm. The last I talked to him he was going to remove and put the stock sticks back in. I remember seeing a write up on the cam swaps in MMFF or 5.0 a couple months back but I usually skip those articles since I don't a Cobra.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top