Ford Mustang Forum banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
1966 coupe 289 manual anybody got info on parts you need where to cut and shut etc for RHD conversion. i'm a qualified welder and will be doing the conversion just if i start from scratch it will take a lot longer, help would be gratefully accepted.
 

·
Registered
Joined
·
5,979 Posts
I have no clue but look for a aus or nz mustang forum.I think you could use the firewall from about the same year falcon rest just cut and move around.
 

·
Registered
Joined
·
5,979 Posts
Right hand drive our cars are left hand drive.Hes from aus i think all there cars are right hand drive so changing his car over would be better for him.
 

·
Registered
Joined
·
895 Posts
I know most states don't require you to change to RHD any longer in AU. Gladstone is on Tasmainia right??? You should get ahold of Alan Valla at Big Al's Auto Works in Kings Park, 02-9622-8289 or [email protected] he is one of the best parts/restoration/coversion guys in AU and he know quite a bit about the RHD conversions.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top