Ford Mustang Forum banner

1966 mustang 289 sputtering and poping

5768 Views 8 Replies 4 Participants Last post by  eliseo65
Hi I have a 1966 mustang and it starts and idles fine but when I let the clutch out and try to move it sputters and bogs even when warmed up so I have to give it lots of throttle. I have read manny fourms and threads and can figure this out it seems like a fuel probably. But when I am cruising at 45 and give it throttle it sputters and I have to lightly give it throttle or else it pops and will stutter pretty bad.

I have a stock 289 but it has a edlbrock 289 rpm intake and a old holley 600 carborator. Also a crane cams points to electronic ignition box and a motor craft distibutor but a stock coil.

I will check the cap and rotor today and wires the plugs are new they are autolite 45 I gapped them 2 off of spec by accident could this be the problem? I also am suspecting it is the coil I put on a msd blaster coil and it burned right up can someone please help me. Any advice would be greatly appreciated. Jason
1 - 1 of 9 Posts
Recent carburetor rebuild?

If not, maybe you need a new diaphragm in the accelerator pump.

Or maybe all you need is a simple adjustment:

https://www.youtube.com/watch?v=k-Nx5HEzvlY&list=PLt1gplJuIET0K2zSlxZB25qvxezzE8MvH
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top