What ammeter is it? It should have had good instructions for wiring it. Two of the terminals are probably for the backlighting. Give me a link to it and I can probably figure it out for you.
1966 Mustang Ammeter Non working.
I purchased a new temperature gauge and ammeter gauge, previous post needed assistance, And I have the water temp gauge working now but the ammeter gauge is not working. I cannot for the life of me locate the solid yellow or solid red lines under the dash so I bypassed the wire harness and ran 14 gauge red wire to the solenoid where the factory red wire ran to but as for the "yellow" wire I do not know where it went to... I am running a 14 gauge "Black" wire for the yellow and well what do I hook this wire up to get the ammeter gauge to work? It does not move at all and well It’s brand new and well there are three small screws on the back of the alternator and I don’t want to try hooking it up to these because this 60 dollar gauge is well expensive and I don’t want to burn it out.
Is the 14 gauge wire to big???
Thanks for the assistance.
Is the 14 gauge wire to big???
Thanks for the assistance.
1 - 1 of 5 Posts
1 - 1 of 5 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ford Mustang Forum
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, builds, modifications, reviews, engine swaps, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
