Ford Mustang Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
23 Posts
Discussion Starter · #1 ·
little help please, I had to redo the two lines from the master cylinder to the distribution block and needed to bleed the brakes. started with right rear and it wont pump fluid out. I pulled the bleeder and it is clear. then I loosened left just a tad and i had fluid spurt out . retried to pump the right and still nothing. I can"t remove the wheel because it has a wheel lock and no tool but could a bad cylinder keep it from bleeding? the line from the distribution valve on the rear end looks good no kinks so I am thinking a bad cylinder? any ideas would help. bill
 

·
Registered
Joined
·
6,575 Posts
You probably need to bleed the master first. This would be the same procedure as "bench bleeding" a new master, but with a buddy helping you you don't have to take it off the car.
 
1 - 2 of 2 Posts
Top