In your title you say brake light, but in the story you say tail lights. So please clarify. Did you loosen or move any part of the steering column or shaft inside the car? If so you may have done something to the wires on the turn switch.
1967 Mustang Brake Light Problem
A few days ago I replaced my steering wheel rag joint, my tail lights were working before then. Now the tail lights seem to be connected to the emergency flashers because when I have the flashers on the lights on my dashboard light up(constantly when pressed flash when not pressed) but not the tail lights(in either situation). I have voltage go through when the flashers are on but not when they're off. I replaced the brake light switch a week before I replaced the rag joint, so I don't think it's that. I also checked all fuses.
Thank you in advanced, if this wasn't clear I'll try to explain another way.
Thank you in advanced, if this wasn't clear I'll try to explain another way.
1 - 2 of 6 Posts
Is it possible you hit one of the harness firewall pass thru connectors? I can't think of anything else in that area to give you this problem.
1 - 2 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ford Mustang Forum
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, builds, modifications, reviews, engine swaps, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
