Ford Mustang Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Im trying to remove the lower control arm on my 67 so i can replace the bushing. Ive taken off the crown nut but the bolt is not budging. Is there a special way to remove these? any other tips? thanks
 

·
Banned
Joined
·
7,170 Posts
strike the spindle on the side, where the bolt goes through it. hit it pretty hard and it will let the bolt go. :bigthumbsup
 

·
Registered
Joined
·
233 Posts
Replace the bushing?

:waveyHI, dne' here,
Are you going to replace just the bushing, or replace the entire lower control arm? I would think I would just replace the entire LCA, it'll be all nice and shiney and new with a new lower ball joint. May as well replace the eccentric that adjusts the camber while your there. Then you'll have to get a front end alignment after you're done.:bigthumbsup
dne'
 
1 - 3 of 3 Posts
Top