Ford Mustang Forum banner

1970 Mustang Coupe Restoration

242 Views 5 Replies 6 Participants Last post by  ONEZ ST
Hello, My name is Erik and I have 2 1970 Mustangs I'm restoring. The 1st one had been completely stripped and new floor pans put in as well as a new headliner. I just finished painting the engine compartment and I'm ready to put the new brake and fuel lines in. Then I'll get the steering put back together and working so then I can put the engine in. I have new wiring from Painless and with the interior completely disassembled I'm going to need advice as to what steps to take first so I don't do something out of order, which I tend to do. The engine is a basic 302 with an Edelbrock manifold and Holly 670 cfm carb but other than that it's stock with a C4 tranny. My next step is to put the new fuel and brake lines in and get the brakes all working, then put the engine in. That part I'm good with. Once I begin with putting the interior together I'll have many questions about where to start and what to do next. so more to come.....


See less See more
1 - 6 of 6 Posts
Welcome to AFM Good luck on your builds
Sounds like a cool build, welcome to the site!
Welcome to the forum! Wow, good luck with the rebuild. Should be alot of fun to work on.

If you get stuck on anything, feel free to ask away. Tons of good info and very knowledgeable folks here. We will be more than glad to help you out.
Welcome to the site!!
Welcome to AFM.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.