Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
I am getting ready to replace the floor pans in my '72 coupe. The area under the rear seat shows a few rust pin holes and should be replaced as well. The problem is that it seems that the only rear floor extensions that I found are for 64-70. The appear to be about 4-5 inches too narrow. Does anybody know where I can find a pair, even if they are from a salvage yard? Thanks.
 

·
Registered
Joined
·
144 Posts
NPD has full length pans for your car, they are 90 bucks a side. Page 146 in their new catalog. Hope it helps.
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #3 ·
Thanks for the reply. I was looking for info on the rear floor extensions. The area under the rear seat. The 71-73 Pony is a few inches wider than than the 65-70 models. Those extensions will not fit without adding metal. Full floor pans go as far back as the edge of the rear seat. Full floor pans I picked up last week at Mustangs Unlimited.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top