1975 motor mounts big problem

409 Views 1 Reply 2 Participants Last post by white cobra, Sep 11, 2012

blindmantattoos

Discussion Starter · Sep 11, 2012

so i have a mustang 2 1975, i had the motor v8 ,302 rebuilt, i took it to the shop personally, and took it out my self, i received her back yesterday and while i was installing the motor the driver side lines up perfectly, but the passenger side is off like 2 inches, it looks like it needs to go up and be pulled towards the fender but if i do that than the other side will be off, im stumbled, note these are the original mounts and motor, any suggestions

Save

1 - 2 of 2 Posts

white cobra

· #2 · Sep 11, 2012

yes put your mounts in VERY loose just a couple threads on the bolts til there all in you may even have to use a hoist to pull on the motor to help align the bolt holes, when all are in then tighten, I've ran into this problem on alot of older cars any make

Save

1 - 2 of 2 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month