Ford Mustang Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
39 Posts
Discussion Starter #1
So I have taken the origianl harness out of the engine bay of the car. My thought is to clean it up. Fix any splices that have been done for aftermarket crap. Is this the route to go or is there another train of thought on this?
 

·
Registered
Joined
·
22 Posts
We are in the same boat and i called 12 different place who advertise custom wire looms (Painless wiring etc.) I have the orij factory wiring blue prints i could scan to pdf if you need , but no one will make one that i found.
I Fas told by a local automotive electric company to put it in a garbage bag with dawn and water and clean it then blow it all off with air. then put connector past in the conections and buy any wire i need in the correct colors and fix what i have.
 
1 - 2 of 2 Posts
Top