NO!!!!!! Your gonna have to check the bearing clearances, and that needs to be done on a stand. Cant just slap bearing in there. Because if they are two tight, youll wipe them out.
1988 Mustang GT bottomend bearings
ok heres one question can u do the bottom end bearings with out pulling the motor?? and i'm thinking about a 351w botom end will the a9l maf computer work with it its set up as a roller block also any answers are greatly appreciated
- Status
- Not open for further replies.
1 - 6 of 6 Posts
G
NO!!!!!! Your gonna have to check the bearing clearances, and that needs to be done on a stand. Cant just slap bearing in there. Because if they are two tight, youll wipe them out.
Is that your final answer......
it better be
because as much as i hate to admit he is right ....
he is.......:gringreen
Im only right every so often, so you wont have to admit that Im right a lot. Just got lucky in this case.:gringreen
ok well that sux so what about the 351w bottom i know everything will swap over except the lower intake but will the a9l computer maf system work as a plug and play ??
G
ok well that sux so what about the 351w bottom i know everything will swap over except the lower intake but will the a9l computer maf system work as a plug and play ??
a9l will work just fine with the 351 is a basic plug & play......
1 - 6 of 6 Posts
- Status
- Not open for further replies.
Ford Mustang Forum
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, builds, modifications, reviews, engine swaps, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Recommended Communities
