Ford Mustang Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
138 Posts
Discussion Starter · #1 ·
Ok, i install 30# injectors an I noticed I can't get the injector harness plug on, because it heats the heater core pipe a little? But now I can't put the water sensor in cause it hits the injector? I'm not sure on what to do? I have a few pictures to help show what I am talking about.
 

Attachments

·
Registered
Joined
·
46,010 Posts
All you should have to do is rotate the injectors around so the harness will plug in, and allow the sensor to tighten. Rotate them around so the harness is towards the back of the engine, not straight up.
 

·
Registered
Joined
·
138 Posts
Discussion Starter · #3 ·
Oh wow, I never thought of that :frustrated:. Thats why I shouldn't work on my care at 1 in the morning. Thank you.
 

·
Registered
Joined
·
46,010 Posts
No biggie... and nothing wrong with working on it at 1am.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top