Ford Mustang Forum banner
Cancel

1989 Mustang 5.0 GT O2 sensor wiring harness help needed

10838 Views 4 Replies 3 Participants Last post by  Marunos, 
S
We've picked up a 1989 Mustang with a 5.0L engine and 5-speed transmission. Unfortunately, there's no wiring harness from the oxygen sensors into the main harness. We need the 8-pin connector schematic for how it connects into the main harness.

We've been scouring forums and all we've been able to find is the EEC pin-out diagram.

Does anyone have the schematic or know where we can find one? Maybe someone has a picture of the connector showing the wiring configuration?

Any help is GREATLY appreciated!
Reply
Save
Like
1 - 2 of 5 Posts
S
Thanks for the info!

I can see the wire colors used in the Mustang Main Harness for connector #40 as shown here. I also see connector #42 shown here in the HEGO O2 harness. The colors

Maybe this is a stupid question but how do I know which color goes to which pin in the connector as it plugs into the main harness? I guess I'm thinking that I need to pull back the casing on the main harness to see what color wires on that side and then match up the wires so that when the male/female ends are plugged in that they line up?
Reply
Save
Like
1 - 2 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Ford Mustang Forum
A forum community dedicated to Ford Mustang owners and enthusiasts. Come join the discussion about performance, builds, modifications, reviews, engine swaps, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
2005-2010 Mustang Talk 2011-2014 Mustang Talk 5.0L Tech Classic Tech 2005-2010 Mustang GT Tech
Top