Ford Mustang Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
103 Posts
couldnt it be just a bent pushrod also? wouldnt that cause it to be loose? even if its slighly bent it would still turn alil. correct? im just asking this because i just had the same issue that im dealing with now.. had a few loose rockers and the rods we actually slightly bent also.. i just hope the lifter isnt an issue and find out when i reassemble everything.. what do you think Eagle?? also is there a way to check the lifters since i have the rockers and pushrods out right now before i put everything back together and waste another 100 on gaskets?

sorry to butt in but this could help us both
 

·
Registered
Joined
·
103 Posts
ya it sounds like a lifter then.. good luck bro.. atleast im not the only one going through this kind of problem right now..haha
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top