Ford Mustang Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
hi, I have a 1991 Mustang that is about 70% disassembled, The engine and transmission are out, {4cyl, auto/od} I left the windows in the doors down when I took everything out and I need to be able to roll them up. Does anyone know how to manualy run the motor from a 12 volt source so I can get my windows up? Anyone know what coulor wires do what in the harness connected to the door? any help would be great. thanks
 

·
Registered
Joined
·
310 Posts
There should be a yellow and a red wire to each motor. Im pretty sure its as simple as putting a 12v wire into either side of the connector and it will wither go up or down. Someone correct me if im wrong.
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #3 ·
there was two yellow wires and two red wires I tried them all in every possible combination but nothing happened. Anymore suggestions? Where could I find a wiring diagram for one?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top