Ford Mustang Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Maybe one of you guys can help me with my troubles?????? I cannot find out where the timing mark 4 the aux shaft goes on my stang!!!! Its been backfiring on me and i have went through most (almost all the motions) is there any advice i can get from anybody,please!!!!!!
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
No,kinda pressed for time,work alot!the internet is purty much all i have for now! My chilton doesnt say enough about my situation,and none of my budies seem to know either.so im hoping you or somebody on this site can point me in the right direction!!!any other pointers?
 

·
Registered
Joined
·
57 Posts
Should be on the lower right side of the belt cover. also check to see if you jumped a tooth on the cam belt.
 

·
Registered
Joined
·
1,854 Posts
it doesn't matter where the mark is on the Aux sprocket, just where you align the distibutor to with the engine set at TDC.
 

·
Registered
Joined
·
6 Posts
I think your car should be a DIS engine. If it is I think it has a crank sensor to fire the ignition and the aux shaft just drives the oil pump. But I'm not sure.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top