Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
208 Posts
Discussion Starter #1
I am swapping a '95 Explorer 8.8" rear into my 'Stang, everything is going ok, I got my leaf spring perches going good, the only problem seems to be the driveshaft. My passenger-side muffler is obstructing the pinion gear adapter for the rear-end. Has anyone else done this swap before? Or maybe a 90's 'Stang 8.8" swap and run into the same problem? :headscratch:
 

·
Registered
Joined
·
3,166 Posts
If the flange type of pinion yoke is still mounted to the pinion, you may have to change to the early style yoke or move the muffler.

Be aware that changing yokes may upset the tooth meshing pattern between the ring gear and pinion if you are not careful.
 

·
Registered
Joined
·
208 Posts
Discussion Starter #3
There is a pnion gear adapter in the rear-end input, I have everything I need to hook it up, the muffler is just in the way! :(
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top