Ford Mustang Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I am currently looking into buying a beater V6 swapping out the motor and putting a 351w bored and stroked to a 408. Yeah i know what all ya'll are thinking, why not go with a 4.6 or 5.0, well thats all too common and i want something different. My plan is to make it fuel injected. I know a lot of people have not done this, but my question is will a 5.0 computer out of another car or truck or a 351 computer plug right up and go, after installation of the new wiring harness, or will i have to have it reprogrammed at the dealership. Thanks
 

·
Registered
Joined
·
1,171 Posts
Making it fit in there is going to be a trial. It can be done of course, but it will take some doing.

As for the EFI, Have you seen the Mass-Flo system? It uses almost all Ford parts. Pretty slick. People have used them on strokers with good results.
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
alright thanks, yeah i know making it fit will be tricky and costly but i figured with the uniqueness it will be worth it ya know
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top