Ford Mustang Forum banner
Status
Not open for further replies.

1996 Mustang GT wiring problems

936 views 4 replies 2 participants last post by  02v6stang 
#1 ·
I just dropped in an engine from a 97 mustang gt and as i was rewiring everything i couldnt find a place for one sensor. it is at the bottom on drivers side along with the 02 sensor connector. This other sensor is actually wired in a few inches away from the 02 sensor connector. It looks like another sensor that would be screwed in somewhere. what could this be and where would it go?
 
Discussion starter · #3 ·
would that affect the starter not to engage? because my old starter had power but was not engaging. so i bought a new one and its doing the same thing. I have no idea where the transmission sensor would go
 
Discussion starter · #5 ·
when i turn the key the starter will get power and spin. but it will not engage. I think that plug is part of the main engine harness except that the wires go below the power steering pulley and ends at the o2 sensor. the plug is about 3-5 inches before the 02.
 
Status
Not open for further replies.
You have insufficient privileges to reply here.
Top