Ford Mustang Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
In a recent inspection at a good year shop i was told i needed front brake pads, calipers, hoses and rotors. As well as rear rotars and a front hub assembly due to bad bearings. I plan on doing this myself, so any insite on the job itself or where to obtain these parts at a fair price would be helpful.
thanks, Chris
 

·
Registered
Joined
·
547 Posts
not a hard job, the hardest part will be torqing the nut back down over the bearings after u replace them. i think u have to torq them down to like 200 ft pounds
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top