Ford Mustang Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter · #1 ·
Ok so today i started the process of taking off the old stuff on my car to make way for the long tubes, catted h pipe, and centerforce clutch. I have 4 bolts out on the left side of the tranny and 3 out on the right, am i missing any cause the tranny wont budge. I thought it was just frozen at first but its not going anywhere. Also do i have to take off the started bolts to get the transmission out? And, is their a secret to getting at the stock header bolts and any easier of a way to take them off?? I have a 97gt.

Thanks,
Mike
 
G

·
it's prob stuck on the dowel pins, spray them wth some PB Blaster or something similar and use a pry-bar to seperate them....
 

·
Registered
Joined
·
69 Posts
Bolts

Yes you do need to remove the starter to drop the trans so don't pry on anything until you do. There are 3 bolts for the starter and top one is a PITA, you really can't see it so you need to do it by feel, good luck.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top