Ford Mustang Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
328 Posts
Discussion Starter · #1 ·
Well I've been dealing with plenty of problems lately with this car and one of them recently is that after I got my gears installed(4.10's), if I floor it from a stop it hits the rev limiter for about a second and then shifts to 2nd. I have an automatic with my tuner and I did adjust the speedometer to my gears. I have no clue why it would do this so if anyone has an auto with gears or have had one; I would appreciate any info as of what might be the culprit of this. Thanks
 

·
Registered
Joined
·
7,401 Posts
Sounds like the shift schedule is a little too high in the tune, or the rev limiter is a bit too low.
 

·
Registered
Joined
·
328 Posts
Discussion Starter · #3 ·
Yeah I have the rev limiter set in drive for 6300 just in case and maybe I'll see if I can lower the shift points a little because the tires just spin and it hits the rev limiter quick in the first gear. Every other one is fine.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top