Ford Mustang Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Just picked up this car from my brother. He had ruined the throw out bearing so I went ahead and ordered a spec stage 1 clutch and billet aluminum flywheel. When it was time to install the flywheel I found that no matter how I fit it, two of the six holes didn't line up. The part number stamped on it matches my car. Somewhat inexperienced with clutches, is this an issue with the part or did I miss something?
 

·
Registered
Joined
·
8,704 Posts
Six bolt engine and six bolt flywheel, correct? Should bolt right up. I have the same flywheel and clutch, it all went together easy as butter.

Would have to say it's an issue with the flywheel, but I don't know what - or how the bolt holes could be off.
 

·
Registered
Joined
·
437 Posts
keep rotating it, there is only one way that thing is going to fit on there, at least that's the way it was for my 8 bolt set up.
 

·
Registered
Joined
·
7 Posts
Discussion Starter #4
SoCal after your install was your clutch pedal very stiff. I got everything put together and that clutch is stout.
 
1 - 4 of 4 Posts
Top