Ford Mustang Forum banner

2005 GT 4.6 rattling/knocking noise when turning/accelerating

3020 Views 10 Replies 6 Participants Last post by  S197_2020
Hi community,

I finally decided to open up a new thread to make use of everybody's knowledge, advise and experiences. I already read trough Dingo7222's thread which sounded exactly like the problem I have with my car. But, I checked the motor mounts and especially the spacing of the steering shaft and came to the conclusion that my problem is different from his.

Repairs that have been recently done:

- Lower ball joints
- inner tie rod ends
- outter tie rod ends
- sway bar links
- both front strut assemblies

After replacing all these parts, the noise is still there but it improved slightly. Especially when I'm turning right and accelerating there is a rattling/knocking and grinding noise. Also when accelerating from a full stop or driving on a bumpy road the noise will come up. You can definitely feel the vibrations. Surprisingly, during left turns the sound disappears. I jumped into the passenger seat today and could feel the knocking/grinding/vibrations under my left foot, pretty close to the middle console in about the left center portion.

The intensity increases when taking longer drives and the car heats up. What I also felt was a drop in power when I shift from the 4th to 5th gear, I don't know if this is also related to the issue. When I pull it out of my garage and go to work, (3 miles one way) everything is fine and I can barely feel it.

Does anybody have a clue what it could be? Maybe something with the drivetrain? (shaft)

I really want to get this fixed as its really annoying and driving me crazy.

Thanks in advance!:grin:

*EDIT: Just took it for another drive. After the car and parts warmed up, when accelerating slowly out of a full stop there is a grinding noise in the section mentioned above, accompanied by little resistance until picking up some speed. It might be a driveshaft bearing, that is something that I am guessing right now.
See less See more
1 - 2 of 11 Posts
You said the problem disappears when you make a left turn, so does the problem become worse when you make a right turn?
I can't help wondering if the driver's side engine mount is shot.
  • Like
Reactions: 1
Could be a bad wheel hub bearing. When my passenger side hub bearing began going out it made a grinding noise and would get worse turning the wheel one direction and less worse in the other.
Yes that's a possibility and in the OP's case, it would be the front driver's side.
1 - 2 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top