Ford Mustang Forum banner

2005 Mustang GT is replacing tranny cooler pipes feasible?

875 5
Can you replace the cooler pipes with flexible hose? The bellhousing bolt that I need to remove for the torque limiters is being blocked by the pipes. I'm sure I could just undo them, but replacing them will allow needed flexibility for the temp gauge and future tranny cooler(s). It looks like there is the formed pipe leading into rubber hose to the cooler and back out the same way. Should some standard rubber hose work for this project or do I need any kind of special fittings or whatnot?
Status
Not open for further replies.
1 - 2 of 2 Posts
I think if I was doin it I would just move the lines for the bolt now and then when your ready I would use some braided lines. Do you think your going to need a bigger cooler with that 20gal :hihi: pan you have?:scratchchin
Well that some cheep insurance then. Did you put the prothane motor mounts in?
1 - 2 of 2 Posts
Status
Not open for further replies.
Top