Ford Mustang Forum banner

2005 Mustang GT ZEX install questions

1078 Views 8 Replies 2 Participants Last post by  BKid
I know there are several threads posted on here, but most of the vehicles Ive read about are manual and mines an automatic. Anyways im looking to purchase the ZEX wet kit for my car, along with the ZEX TC window switch. I have a few main questions.
1. As for the WOT switch, If i was to be at the track and floor it, due to it being a WOT switch, it would start spraying immediatley as the throttle was put to the floor correct? That is why the TC window switch should lock out first gear and spray between 2800-5400 correct?
2. Im currently running the SCT 93 canned tune in the SF3, i have an off road x, mac axle backs, cmcv deletes and CL racer intake. Would I need colder plugs and a nitrous tune to run a 75 shot? Or could i effectively run the same thing Im doing now, without causing damage...(a dyno tune is in the future, one i get gears and everything else...)
3. Is there anything else i absolutely need to run the ZEX kit? I know many may say bottle heater, remote opened, ETc....those dont seem to be neccessities, as I live in florida and i really dont think a heater is 100% needed for the ammount I will be spraying here and there. I plan on getting the gauge for the bottle...is there any other expenses needed? thank you
Status
Not open for further replies.
1 - 4 of 9 Posts
I know there are several threads posted on here, but most of the vehicles Ive read about are manual and mines an automatic. Anyways im looking to purchase the ZEX wet kit for my car, along with the ZEX TC window switch. I have a few main questions.
1. As for the WOT switch, If i was to be at the track and floor it, due to it being a WOT switch, it would start spraying immediatley as the throttle was put to the floor correct? That is why the TC window switch should lock out first gear and spray between 2800-5400 correct?
2. Im currently running the SCT 93 canned tune in the SF3, i have an off road x, mac axle backs, cmcv deletes and CL racer intake. Would I need colder plugs and a nitrous tune to run a 75 shot? Or could i effectively run the same thing Im doing now, without causing damage...(a dyno tune is in the future, one i get gears and everything else...)
3. Is there anything else i absolutely need to run the ZEX kit? I know many may say bottle heater, remote opened, ETc....those dont seem to be neccessities, as I live in florida and i really dont think a heater is 100% needed for the ammount I will be spraying here and there. I plan on getting the gauge for the bottle...is there any other expenses needed? thank you
1. I spray off the line with my auto trans ,no need for a window switch with an auto.
2 No you stock plugs will do for a 75 shot. Now you will go to a 100 shot trust me. Then get the Brisk silver racing plug 314vs 1 stage colder.
3 You will need , electrical tape,zip ties. I use an extra arming switch so no mishaps.
ALSO READ THIS:http://www.allfordmustangs.com/foru...dered-zex-nitrous-kit-my-2006-mustang-gt.html
What did you gap them at? Also running the 75.. is that stock sct tune OK till i bump to 100 with Dyno tune? Thanks for your help too!
I would have the tune tweaked some say you don`t I disagree. I don`t think you read my thread.
There needs to be some timing adjustments I believe it is 1 degree for every 50 shot so 2 degrees for 100 shot. I think that is what it was suppose to be.
Gap the 1 stage colder plugs .38 for a 75 shot and .35 for a 100 shot. I would forget about a window switch. Don` t spray in overdrive or with traction control on. You don`t have to have a tune for a 75 shot. I would just go to the 100 shot ,I never even tried the 75 shot to be honest. I just got the Brisk plugs from a great friend . I may of had to wait a long time if that did not happen.
1 - 4 of 9 Posts
Status
Not open for further replies.
Top