Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1
Ok guys so im getting my 4.10's in two weeks:gringreen.....
But i know the top speed the driveshaft can take is greatly reduced. I plan on an alumnium driveshaft but i was wondering a safety loop would help temporarily until i get enough money to get one.
As long as i don't cruise at 120 right?
BTW:2005 v6
 

·
Registered
Joined
·
61 Posts
Discussion Starter #3
Yea just i have a place to legally do a high speed run.:bigthumbsup
I just wanted to kno that as long as I dont stay at the top speed for long will i be ok with a safety loop for now
 

·
Registered
Joined
·
225 Posts
i'd be a little nervous even with the loop. I wouldn't go over about 90 loop or not. The drive shaft rotational speed with 4.10s at around 90 mph is equal to going 120 with 3.31's.

Try to stay 80 or lower til you get a drive shaft.

Btw if yourinterested in buying gears I'm selling them brand new on ebay with a buy it now price of about 75 dollars less than american muscle. bidding started at .01 $ and will end sunday night.

Search "mustang v6 4.10 gears bearing"

good luck!
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top