Ford Mustang Forum banner

Status
Not open for further replies.
1 - 9 of 9 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
Hi
I was tuning my automat when those codes was givem by the SCT tuner. What have I done wrong? And how do I repair it.
i have cleared the codes with the tiner but as soon as i start the engine the codes are there again.
Any suggestions?

/Mats Östberg
 

·
Registered
Joined
·
13,191 Posts
P2104 Throttle Actuator Control System - Forced Idle
P2111 Throttle Actuator Control System - Stuck Open
 

·
Registered
Joined
·
10,877 Posts
I would reflash it to stock, turn it on and off a couple times and then reflash the new tune. Who did you get your tune from?
 

·
Premium Member
Joined
·
72,882 Posts
Have you made any other changes to the car? Check your connections to the throttle body.
 

·
Registered
Joined
·
19 Posts
Discussion Starter #6
No I havent done any changes. The connections to the throttlebody is OK. I tried to disconnect the connections one by one and when i started the car the rpm went up to 1500 rpm. I then cinnected them again and the trottle didnt respons.
 

·
Premium Member
Joined
·
72,882 Posts
No I havent done any changes. The connections to the throttlebody is OK. I tried to disconnect the connections one by one and when i started the car the rpm went up to 1500 rpm. I then cinnected them again and the trottle didnt respons.
Sounds like the TPS may have failed.
 
1 - 9 of 9 Posts
Status
Not open for further replies.
Top