3.7L Braided Engine Hose Dress Up Kits Out There Anywhere?

1407 Views 4 Replies 3 Participants Last post by Ltngdrvr, Aug 4, 2011

V6 Cannonballer

Discussion Starter · Aug 3, 2011

Perhaps I'm several decades behind the times on this one, but I'd like to dress up my engine bay with braided hoses.

I've been searching the web but it appears no one makes braided hose kits (steel, carbon fiber, or otherwise) specifically for the 2011+ 3.7L Mustang.

Are those universal kits on eBay any good? Are they too ghetto or can they be made to look really nice if someone is careful?

Would braided hoses/hose covers be a problem in a place that already bakes miserably in the summer?

I'd just like to spruce up the engine bay a bit but an oil cap here and a T-handle there seems like too little reward.

If I had the time and another vehicle I'd take the valve covers and other parts in to get powder coated but that's out of the question right now.

2011 3.7L purchased new on 10 Sep 2010: JLT carbon fiber CAI, BBK 73mm throttle body, Lone Wolf ported intake manifolds, E3 DiamondFire spark plugs, hY-roader tuned length shorty headers, data logged/dialed-in MPT 91 octane tune, custom H-pipe with mid-mounted mufflers and side-dump exhaust booms, Spec Stage 1 clutch and flywheel assembly, Steeda short-throw shifter and bracket, DSS 3.5" aluminum driveshaft, GT500 3.55's, Scott Drake '05-09 GT strut tower brace, Steeda Ultra-Lite front lowering springs, Koni Yellow adjustable shocks and struts, Chromoly rear lower control arms, H&R 20mm hub centric wheel spacers, 19x9.5 GT/CS wheels, Y-Rated street radials, Roush GT fascia with fog lights and factory V6 grille, BBR 3" cowl hood with custom DIY heat extractors, Cervini's '05-09 Stalker side skirts, Cervini's '05-09 Eleanor rear valance, Roush rear wing, American Muscle rear blackout panel, shorty antenna, paint refreshed in August 2021.

Save

1 - 1 of 5 Posts

Dirtistasty2

· #2 · Aug 3, 2011

You can probably just measure the hoses and fittings and order them yourself online or at a local hose or pump distributor (Parker Store, Grainger). You can even pick cool looking anodized aluminum fittings that are red or blue. Don't worry about heat with braided hoses a lot of them are meant to withstand high heat and pressure.

Save

1 - 1 of 5 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month