Ford Mustang Forum banner

3.8l, tips for making TB gasket removal easier

965 Views 3 Replies 3 Participants Last post by  chfchad
I'm in the process of replacing the throttle position sensor and I figured I'd kill two birds with one stone by removing the throttle body, throughly cleaning it (was rather dirty), and replacing the gasket but the old one is on there pretty well, I am wondering if there were any tips to removing gaskets easier.:worship
1 - 2 of 4 Posts
thanks for the replies, luckily I had a really sharp knife in the kitchen that made quick work of it w/o leaving any scratches, but i'll keep these ideas in mind for next time.:bigthumbsup
1 - 2 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top