Ford Mustang Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
I don't have a 302 to measure. I need to buid a stand to load an engine and tranny onto in the back of by truck. just something simple. a rectangular box to sit the oil pan into and then strap it to the tie-down points. then block up the output shaft on the tranny. Could somebody give me a suggestion for the inside deminsions of what the box should be. will I need 2X10's or 2X12's to mame it deep enough. thanks Jim
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #4 ·
Thanks silverblueBP never thought of an old tire, I'm a woodworker and always try ti make jigs out of wood. Thanks for the chart Acooljt. I'm sure it will come in handy later. Jim
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top