Ford Mustang Forum banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I recently was rear ended in my 1997 GT mustang. To save the car I brought a 1997 cobra body with no engine or transmission.

I need to know is the computer pinout of the cobra and GT the same so that i can put in the GT's computer ?
 

·
Banned
Joined
·
9,216 Posts
welcome to the parking lot!

id use the GT computer since its on a non SC cobra motor.

i could be wrong
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
welcome to the parking lot!

id use the GT computer since its on a non SC cobra motor.

i could be wrong
well no see I know that. but you know the "permanet" wireing harness thats in the chassis that goes from the computer to the engine compartment. I need to know if i need to replace that. Basically I need a diagram for the 97 cobra and 97 mustang. but thanks I knew that tho :p lol
 

·
Banned
Joined
·
9,216 Posts
oh lol... it should be clsoe but there will prolly be some loose ends you wont use.

teh battery cables should be about the same


but the harness i dunno good luck!
 

·
Registered
Joined
·
5 Posts
Discussion Starter #5
Well can i get anyhelp from this .Its basically a 97 GT motor and its engine harness going on to a 97 cobra chassis computer harness and body. The GT is also a Automatic and not a Manual like the Cobra is.

I need halp fast cause i need to know if i need to go take out the under dash harness now.

Thanks
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top