Ford Mustang Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
I currently have a built bottom end H-Beam manley rods and CP pistons all forged.. My question is where can I find some main cap bolts? It's all assembled but Im not sure if the shop who assembled it used the factory torque to yield bolts or not that i had dropped the block off with so I dont wanna risk it.. I'm looking for some ARP ones but all i can find is the main studs. Also, any tips you guys can give me regarding the engine build as far as precautionary steps. Thanks
 

·
Registered
Joined
·
173 Posts
ARP should make some. If not you might try some Ford Racing ones. I think they still make stuff for the old 4.6's
 

·
Registered
Joined
·
1,204 Posts
Get the studs! Much stronger then any bolt.
 

·
Registered
Joined
·
28 Posts
You can also get them from the dealership. The crankshaft doesn't get nearly as much wear and torque on it as connecting rods and pistons.
 
1 - 6 of 6 Posts
Top