Ford Mustang Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter #1
I have a 97 4.6 mustang gt with a 2001 PI head swap. I have the 2001 Trick Flow Track Heat upper and lower intake manifold kit. I'm confused as to where my vacuum lines connect and which lines connect to the 3 brass barbs (1 large and 2 small) that come out the passenger side of the upper intake. I've messaged trick flow but they were still a little vague in their response. Any help would be greatly appreciated. Thank You

-Justin
 

·
Registered
Joined
·
125 Posts
I'm not familiar with trick flow (as in i've never used it not i've never heard of it) but vacuum is vacuum. As long as the hoses are the same size (if not it should be easy to tell which hose fits where) they should all be interchangeable.

by "3 brass barbs on the upper intake" I'm assuming that means your vacuum tree, that tree puts out the same vacuum to each connection on it, assuming the same hole diameter, so it's interchangeable and your engine won't know the difference.

Unless there's some valve/solenoid/you aren't talking about the vacuum tree or something I don't know about, and in that case I'm sure someone else will chime in.
 

·
Registered
Joined
·
31 Posts
Discussion Starter #3
Thank you for your reply kilonia. I assumed the same thing but wanted to double check with others. I've out so much time and money into this project that I want to make sure everything is correct! Thanks again,
Justin
 

·
Registered
Joined
·
6,859 Posts
Might be handy to include pictures and the reply from Trick Flow. Maybe someone can figure it out.
 
1 - 4 of 4 Posts
Top